The  Servo Electric Take Out SETO picks up the containers from the blow mold, moves them over the dead plate for cooling and afterwards releases the containers on the dead plate. 

The Ware Handling Supervision WHS, fully integrated in the FlexIS timing, rejects incorrectly positioned containers at the Hot End. The unit uses a light barrier to detect cullet and "stuck" or "down" ware on the conveyor belt. 

The FlexPusher mechanism transfers the containers from the dead plate onto the running conveyor. It combines the motion of two independent servo motors to generate the sweep out motion. 

The new steel conveyor aims to combine all the different customer needs. This new standard improves the stiffness, reduces the reach distance, optimizes the wind box for equal flow with an option for two on/off controls, integrates the pusher cables and provides a height-adjustable dead plate.

The Ware Transfer moves the containers from the machine conveyor to the Cross Conveyor. The transfer wheel has to cope with spacing variations and still transfer the containers with consistent spacing onto the Cross Conveyor.

The Cross Conveyor has a unique cast iron girder, reducing vibrations and minimizing distortion due to the hot environment. It reduces installation service requirements (fluid cooling) and guarantees a long equipment life.

The new three axis FlexStacker 2 is a result of a joint development project. It uses the FlexIS control hardware from the IS machine. This enabled the introduction of a pioneering human interface with built-in expert knowledge, allowing easy setup of the new stacker without the need of "specialists".